Arduino MKR FOX1200
  • Arduino MKR FOX1200
  • Arduino MKR FOX1200

Arduino MKR FOX1200

42,70 €
Tasse incluse
Int.s.
  • 1
MKR FOX 1200 è una scheda che combina le funzionalità di connettività Zero e SigFox. Otterrete un abbonamento gratuito di 2 anni alla rete Sigfox con la scheda (per un massimo di 140 messaggi al giorno), così come l'accesso gratuito al servizio di geolocalizzazione Spot'it che consente di monitorare la scheda senza GPS o alcun hardware aggiuntivo.
 
Data planning
The MKRFOX1200 price includes a subscription to the SigFox network for two years. The plan will be automatically activated after the fourth message has been sent. You can send up to 140 messages per day.
Antenna
The MKR FOX 1200 is equiped with a GSM  micro UFL connector.  Please check that the antenna you use can accept frequencies in the SigFox's range (868 Mhz). 
Please note: for best result, do not attach the antenna to a metallic surface like car chassis, etc.
Batteries, Pins and board LEDs
Battery capacity: The connected batteries must have a nominal voltage of 1.5V 
Battery connector: If you want to connect a battery pack (2x AA or AAA) to your MKR FOX 1200 use the screw terminal block.
Polarity : as reported on the silk in the bottom of the board, positive pin is the closest to the USB connector
Vin: This pin can be used to power the board with a regulated 5V source. If the power is fed through this pin, the USB power source is disconnected. This is the only way you can supply 5v (range is 5V to maximum 6V) to the board not using USB. This pin is an INPUT.
5V: This pin outputs 5V from the the board when powered from the USB connector or from the VIN pin of the board. It is unregulated and the voltage is taken directly from the inputs. 
VCC: This pin outputs 3.3V through the on-board voltage regulator. This voltage is 3.3V if USB or VIN is used and equal to the series of the two batteries when they are used
LED ON: This LED is connected to the 5V input from either USB or VIN. It is not connected to the battery power. This means that it lits up when power is from USB or VIN, but stays off when the board is running on battery power. This maximizes the usage of the energy stored in the battery. It is therefore normal to have the board properly running on battery power without the LED ON being lit.
On board LED: On MKRFOX1200 the onboard LED is connected to D6 and not D13 as on the other boards. Blink example or other sketcthes that uses pin 13 for on board LED may need to be changed to work properly.

Here you can add custom original content(text, images, videos and more) for each product page.

6 altri prodotti della stessa categoria: